Universal Transconductance Amplifier
(UTA)
Below you will find a table listing the cost of various configurations of the UTA amplifier. Please call (510) 848-5725 or email info@emesystems.com to place your order.
UTA
| UTA | Standard UTA with polycarbonate enclosure Specify LI-COR Sensor Type Used (LI-190, 200, 210) Specify output voltage or gain required. | $130 |
| /BNC | BNC connector on input | add $10 |
| /LL | Higher accuracy at low light levels. Recommended when using a Photometer to measure indoor light levels. Power supply typically less than 15 volts. Call if you need to run on a higher power supply. | add $10 |
| /NE | No enclosure - Amplifier electronics only | subtract $15 |
Accessories
| extra PG7 gland nut | call |
| 3-conductor cable | $7 |
| fuel line tubing | included |
| HOBO VIC cable | $8 |
In order for EME Systems to customize and calibrate your UTA amplifier, when ordering please provide the following information:
- the type of LI-COR sensor you will use with your UTA (LI-19x PAR sensor, LI-200 Pyranometer, or LI-210).
- the output level or specific gain that you require.
- whether you require a BNC connector (SA model) or screw-down terminals (SZ model).
- whether you will be using your UTA amplifier and LI-COR sensor with an Onset HOBO data logger.
- your power requirements.